Oscilloscope Demonstrator Trainer

Dealership

Support Team

Payment & Shipping

Oscilloscope Demonstrator Trainer

Oscilloscope Demonstrator Trainer is specifically designed for the study of working of an oscilloscope in an open form. The Controls are placed actually at the place as they are in the layout schematic. Thus a trainee can easily locate any section, & components in the section and study it thoroughly. The function controls and the adjustment controls are fully accessible to the trainee to verify their effect on the working of the scope.

Features

Oscilloscope in open form with all components and controls placed on single PCB
Amplifier, Time base, Channel section signal available on test points
Separate sections for PS, EHT, VA, HA, TB & Trigger for easy identification
Fault creation & rectification provided
Track printing with different colours on different sections on component board for easy circuit training
Legend Printing on PCB for easy identification of components
Can be used as a standard 20 MHz Dual Trace Oscilloscope

Specifications :

Operating Modes :

Channel I, Channel II, Channel I & II Alternate or chopped, Controls
provided on PCB. Channel selection signals available at Test points. X-Y
operation 1:1

Vertical deflection (Y) :

Identical channels
Bandwidth : DC-20 MHz (-3 dB)
Risetime : 17.5 ns (approx.)
Deflection coefficients : 12 calibrated steps 5 mV / cm – 20 V / cm (1-2-5 sequence)
Accuracy : ±3 %
Input Impedance : 1 MW II 30 pF
Input coupling : DC – AC – GND
Maximum Input voltage : 350 V (DC + Peak AC) Pre-Amp, Final Amp Outputs at Test Points

Timebase :

Time coefficients : 18 calibrated steps, 0.5 ìs / cm – 0.2 s / cm (1-2-5 sequence) with magnifier x 5 to 100 ns / cm, with variable control to 40 ns / cm

Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore